Allied Telesis DNC10 Series, Инструкция по установке и эксплуатации

Страница: 38 / 118

Chapter 2: Installing the Hardware
38
Connecting the Network Cable
Depending on the type of DNC10 series network adapter installed, it is
equipped with an SFP+, fiber optic, or copper RJ45 port. To connect the
network adapter to the network, you must have a cable with the
appropriate connector.
DNC10LC Fiber
Optic Cable
To connect a fiber optic network cable to the duplex LC connector on the
DNC10LC network adapter, perform the following procedure:
1. Prepare a fiber optic cable with an appropriate connector.
Warning
The fiber optic ports contain a Class 1 laser device. When the ports
are disconnected, always cover them with the provided plug.
Exposed ports may cause skin or eye damage
.

L4
2. Remove the dust cover from the duplex LC connector on the fiber optic
port.
3. Connect one end of the cable to the network adapter.
4. Connect the other end of the cable to the fiber optic port on a remote
network device.
5. Load the driver as described in Chapter 3, “Installing the Driver
Software” on page 41.
DNC10SP SFP+
Transceiver
The network adapter requires an SFP+ transceiver and an appropriate
cable to connect to the network.
1. Insert an SFP+ transceiver into the SFP+ port on the network adapter
until the SFP+ transceiver snaps into place in the port.
2. Remove the dust cover from the SFP+ transceiver.
3. Connect one end of the cable to the SFP+ transceiver.
4. Connect the other end of the cable to the appropriate fiber optic port
on a remote network device.
5. Load the driver as described in Chapter 3, “Installing the Driver
Software” on page 41.