Allied Telesis DNC10 Series, Инструкция по установке и эксплуатации

Страница: 34 / 118

Chapter 2: Installing the Hardware
34
Installing a Network Adapter
The following instructions apply to installing a DNC10 series network
adapter in most systems. Refer to the manuals that were supplied with
your system for details about performing these tasks on your particular
system.
To install the network adapter, perform the following procedure:
1. Review the “Pre-Installation Checklist” on page 31 and “Reviewing
Safety Precautions” on page 29.
Before installing the network adapter, ensure the system power is OFF
and unplugged from the power outlet, and that proper electrical
grounding procedures have been followed.
Warning
The module is being installed in a system that operates with
voltages that can be lethal. Before you remove the cover of your
system, you must observe the following precautions to protect
yourself and to prevent damage to the system components.
– Remove any metallic objects or jewelry from your hands and
wrists.
– Make sure to use only insulated or nonconducting tools.
– Verify that the system is powered OFF and unplugged before
accessing internal components.
– Installation or removal of modules must be performed in a static-
free environment. The use of a properly grounded wrist strap or
other personal antistatic devices and an antistatic mat is strongly
recommended.

E39
2. Remove the system cover and select any empty PCIe slot. See Figure
9 on page 35.
If you do not know how to identify a PCIe x4 or larger slot, refer to your
system documentation.