Allied Telesis AT+TQm5403, Руководство по установке, Страница: 24 / 58

Chapter 1: Product Description
24

Five single color LED’s:
LAN1
LAN2
2.4 GHz - 2.4 GHz radio band
5 GHz1 - W 52 and W 53 radio bands
5 GHz2 - W 56 radio band

One dual color LED (i.e. Power LED)

Kensington lock port

Ceiling, wall, or table top installation
Management
Access
Access to manage the software features of the access point are:

Standalone

HTTPS
LAN Port
Both access point models are equipped with two Ethernet ports - LAN1
and LAN2. The LAN1 port is capable of receiving PoE+ power (PD port)
as the primary power or standing by as the backup power source for an
external power supply unit.
Note
For more information about the primary and backup power, see
“Redundant Power Supply” on page 26.
The LAN1 and LAN2 ports are capable of transmitting and receiving
Ethernet traffic and are typically connected to an Ethernet switch.
Power over Ethernet Plus (PoE+)
Both access point models support Power over Ethernet Plus (PoE+) on
the LAN1 port. The access point is a PoE+ Class 4 powered device and its
maximum power consumption is 25.5 watts. When the LAN1 port is
connected to a PoE+ Ethernet power source and no external power supply
is connected to the DC Input jack, the access point receives its power over
the same LAN1 network cable that carries the network traffic.
Connector Type
The LAN ports have an eight-pin RJ45 connector. The port uses four pins
of the connector at 10/100 Mbps and all eight pins at 1000 Mbps. Refer to
the tables in “Port Pinouts” on page 51 for the pin assignments.