Installation and User’s Guides
This document contains an abbreviated version of the installation instructions for the
MWS Series Access Points Installation Guide. For complete installation instructions and
installation safety statements, see the product documentation on the Allied Telesis web site
at
www.alliedtelesis.com
.
Safety and Electromagnetic Emissions Certificates
For Safety and Electromagnetic Emissions certificates, refer to MWS Series Access Point
Installation Guide.
European Union Restriction of the Use of Certain Hazardous
Substances (RoHS) in Electrical and Electronic Equipment
This Allied Telesis RoHS-compliant product conforms to the European Union Restriction of
the Use of Certain Hazardous Substances (RoHS) in Electrical and Electronic Equipment.
Allied Telesis ensures RoHS conformance by requiring supplier Declarations of Conformity,
monitoring incoming materials, and maintaining manufacturing process controls.
Europe - EU Declaration of Conformity
This device complies with Directive 2014/53/EU issued by the Commission of the European
Community. For more information, refer to MWS Series Access Point Installation Guide.
Note
Note
For the EU conformity statement, contact an Allied Telesis office listed on our web
site at http://www.alliedtelesis.com/contact.
Copyright
2017 Allied Telesis, Inc.
All rights reserved. No part of this publication may be reproduced without prior written
permission from Allied Telesis, Inc.
Redundancy Power Supply
The access point is equipped with two PoE+ capable LAN ports. In addition to the PoE+
ports, this device can drain power through the DC jack. When the power supply unit on
the access point fails, it switches to the PoE+ port to drain power.
Note
The AC adapter is
not
included in the shipping box. You must purchase the
AT-MWS0091 AC adapter separately.
Kensington Key Hole
The access point has the Kensington key hole on the side panel.
Installation Orientations
The access point can be installed on a table, ceiling, or wall.
Installing the device with the Allied Telesis logo upside down is
not
allowed.
LEDs
The LEDs display status information.
Quick Installation Guide
AT-MWS2533AP
Simultaneous Dual Band Access Point
613-002444 Rev. B
*613-002444 Rev B*
Kensington Key Hole
Correct Table Installation
Correct Ceiling Installation
Correct
Correct
Correct
Incorrect
LED State
Description
Power
Green
The access point is powered ON and operating
normally.
Blinking Green
The access point is rebooting or software is
upgrading.
Off
The access point is
not
receiving power.
Blinking Amber
The configuration has being reset to the factory
default settings.
LAN 1
Green
A valid link is established on the port at
1000Mbps.
Blinking Green
Data is being transmitted/received at
1000Mbps.
Amber
A valid link is established on the port at 10Mbps
or 100Mbps.
Blinking Amber
Data is being transmitted/received at 10 Mbps
or 100Mbps.
Off
No link is established.
LAN 2
Green
A valid link is established on the port at
1000Mbps.
Blinking Green
Data is being transmitted/received at
1000Mbps.
Amber
A valid link is established on the port at 10Mbps
or 100Mbps.
Blinking Amber
Data is being transmitted/received at 10 Mbps
or 100Mbps.
Off
No link is established.
2.4GHz Wifi
Green
The 2.4GHz Wi-Fi interface is enabled.
Blinking Green
Data is being transmitted/received at the
2.4GHz frequency band.
Off
The 2.4GHz Wi-Fi interface is disabled.
5GHz Wifi
Green
The 5GHz Wi-Fi interface is enabled.
Blinking Green
Data is being transmitted/received at the 5GHz
frequency band.
Off
The 5GHz Wi-Fi interface is disabled.
1
2
3