Allied Telesis AT-FS710/16, Руководство по установке

Страница: 33 / 64

FS710 Series Ehternet Switch Installation Guide
33
Unpacking the Switch
To unpack the FS710 Series switch, perform the following procedure:
1. Remove all components from the shipping package.
Note
Store the packaging material in a safe location. Allied Telesis
recommends that you use the original shipping material in the event
that a problem occurs and you need to return the unit.
2. Place the switch on a level, secure surface.
3. Verify that the following hardware components are included in your
switch package:

One FS710 Series switch

Four rubber feet are provided depending on the model:
– With adhesive back for desktop installation of the AT-FS710/5
and AT-FS710/5E models only;
– With four mounting screws for desktop installation of the
AT-FS710/8, AT-FS710/8E, AT-FS710/16, AT-FS710/16E and
AT-FS710/24 models.

Two 10mm x 22mm nylon anchors and two 3.5mm x 16mm
pan-head screws (provided only with the AT-FS710/5 and
AT-FS710/5E models for wall mounting.)
Note
Wall mounting hardware for all models except for the AT-FS710/5
and AT-FS710/5E must be purchased separately.

AC Power cord - only for the FS710 Series models with AC power
plug.

Switching AC/DC adapter - only for the FS710/xxE models with
external DC power source
If any item is missing or damaged, contact your Allied Telesis sales
representative for assistance.
Note
If you plan on mounting the unit on a wall or in a rack, see the
information in Table 3, “Wall and Rack Mount Brackets” on page 26.
This table shows brackets options available that may need to be
ordered separately from the FS710 Series switch.