Allied Telesis AT-FS710/16, Руководство по установке

Страница: 42 / 64

42 42
3. Orient the brackets against the sides of the switch.
4. Have another person hold the switch with the brackets at the wall
location where the switch is to be installed. Use a pencil to mark the
wall for the locations of the four holes in the brackets. See Figure 19.
Figure 19. Marking the Screw Hole Locations
Note
Figure 19 shows the front panel oriented toward the left side.
However, the switch can be mounted on the wall with the front panel
facing left, right, up or down.
5. Pre-drill the marked locations on the wall at the locations marked in
Step 4 as follows:
a. For a wood wall, drill a 1.5mm (1/16”) pilot hole for screw. (No
anchors are required for mounting brackets on a wood wall.)
b. For a sheet rock, concrete or cinder block wall, drill a 6mm (1/4”)
hole for anchor.
6. If the wall you are mounting the unit on is wood construction, then
proceed to Step 8.