Allied Telesis AR2050V, Справочник по командам, Страница: 1213 / 2824

C613-50186-01 Rev B Command Reference for AR2050V 1213
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
BGP
AND
BGP4+ C
OMMANDS
NEIGHBOR CAPABILITY ROUTE
-
REFRESH
neighbor capability route-refresh
Overview Use this command to advertise route-refresh capability to the specified BGP and
BGP4+ neighbors.
Use the no variant of this command to disable this function
Syntax neighbor < neighborid > capability route-refresh
no neighbor < neighborid > capability route-refresh
Mode Router Configuration
Default Enabled
Usage Use this command to advertise to peer about route refresh capability support. If
route refresh capability is supported, then router can dynamically request that the
peer readvertises its Adj-RIB-Out.
Parameter Description
< neighborid > {
<ip-address>
|
ipv6-addr>
|
<peer-group>
}
<ip-address>
Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr>
Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group>
Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the
neighbor peer-group (add a neighbor)
command, and neighbor route-map command.
When this parameter is used with this
command, the command applies on all peers in
the specified group.