C613-50186-01 Rev B
Command Reference for AR2050V
1126
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
BGP
AND
BGP4+ C
OMMANDS
BGP
CONFIG
-
TYPE
bgp config-type
Overview
Use this command to set the BGP configuration type to either
standard
or
enhanced
types. When you configure the
enhanced
type, then BGP and BGP4+
communities are allowed to be sent and received by default. The
enhanced
type
is configured by default.
Use the
no
variant of this command to restore the default BGP configuration type
(
enhanced
).
Syntax
bgp config-type {standard|enhanced}
no bgp config-type
Default
By default, the BGP configuration type is
enhanced
.
Mode
Global Configuration
Usage
Note that the
enhanced
type default configuration may cause issues in some
networks if unauthorized BGP peers are advertising BGP communities to adjust
routing decisions.
Changing modes requires you to
reload
your device for the change to take effect:
When your device reloads, it will load with the standard BGP settings commonly
used by most vendors. Apply the
standard
type configuration if you have
interoperability issues.
Examples
To specify the
standard
BGP configuration type, enter the following commands:
awplus#
configure terminal
awplus(config)#
bgp config-type standard
Parameter
Description
standard
Specifies the industry standard style configuration. After setting the
configuration to standard, make sure to use the
command to send out BGP community attributes.
The
command is enabled in the Global
Configuration mode and is shown in the configuration.
enhanced
Specifies the enhanced style configuration. The enhanced
configuration type requires no specific configuration for sending out
BGP standard community and extended community attributes. The
command is enabled by default in the Global
Configuration mode and is not shown in configuration output.
awplus(config)#bgp config-type standard
awplus(config)#exit
awplus#reload
reboot system? (y/n): y