Allied Telesis AR Router Series, Справочник по аппаратуре

Страница: 23 / 111

Hardware Reference 23
C613-03031-01 REV E
Figure 7: Front and rear panels of the AT-AR370(U) router.
Table 7: Functions of the front panel LEDs on the AT-AR370(S) router.
LED Function
LAN Link Lit when the Ethernet interface is connected to a device (e.g., a hub),
which is generating link pulses. This LED is normally lit.
LAN Txd Lit when data is being transmitted over the Ethernet interface.
LAN Coll (yellow) Lit when a collision is detected on the Ethernet interface.
LAN Rxd Lit when data is being received on the Ethernet interface.
WAN Syn Lit when data is being transmitted or received over the synchronous
interface.
WAN ISDN Lit when data is being transmitted or received over the ISDN interface.
WAN Active Lit when the BRI has successfully completed the exchange of INFO 1 and
INFO 2 signals, and INFO 3 and INFO 4 signals are present on the link.
This means that the ISDN interface is correctly connected to a working
NT device.
System (red) This LED is not normally lit. It is used to signal various system conditions
(e.g., when the processor executes the reboot sequence). Generally it
signals a possible fault condition, but it will light briefly during power-
up and operator initiated reboot.
Run Lit when the internal processor is executing code. If the processor stops
for any reason (a fault condition), then the LED will not be lit.
Power Lit when power is supplied and the router is switched on.
Rear Panel
370UFRP
SYNCHRONOUS 0
CONFIG
Asynchronous
ports
DIP
switch
4 3 2 1
Ethernet port Synchronous port
AR370
Front Panel
PORT 1 (RS232)
PORT 0 (RS232)
ETHERNET 0
HUB PC
MDX
AR370
ISDN-U BRI 0
BRI-U ISDN Port
Access Router
COLLISION
10BASE-T WAN
LINK
TRANSMIT
RECEIVE
SYN
ISDN ACTIVE
SYSTEM RUN POWER
Model name
LEDs
100–240 VAC, 50–60Hz, 300mA.
DISCONNECT MAINS SUPPLY BEFORE REMOVING LID
NO USER SERVICEABLE PARTS
Power inlet