Preliminary Information
About the Control
The control on the machine is an advanced, graphical, program-
mable computer that lets the owner control most machine fea-
tures by interacting with the control.
This control allows the owner to program custom cycles, run di-
agnostic cycles, and retrieve audit and error information.
Machines shipped from the factory have default cycles and wash
temperature settings built in. The owner can change the default
cycles or any cycle.
IMPORTANT: It is extremely important that the machine
has a positive ground and that all mechanical and elec-
trical connections are made before applying power to
or operating the machine.
Power Failure Recovery
If a cycle is in progress and the power fails, the cycle status is
saved in memory. When the power recovers, the washer will re-
sume into the previously active cycle if so programmed by the
owner.
The owner may program a special feature called POWER FAIL
RESET which sets a maximum power failure duration. To pro-
gram this feature, refer to
.
If the length of the power failure is greater than the POWER
FAIL RESET time, the control will end the cycle and the display
will revert back to the ready mode.
On drain pump models, if the wash basket is full of water, the
control will lock the door and pump out the water.
Communications
The control may be programmed manually, by infra-red or USB
with an external device, or by a network. A limited number of
features can be programmed by a card reader.
Infra-red Communications
An external device, such as a PDA, allows the owner to program
and retrieve information from the control without touching the
keypad. An external device greatly expands the programming op-
tions available to the owner. However, the external device is not
required to program and operate the machine. The operation of an
external device and the advanced features available are covered
separately in the instructions included with the external device
software. Contact Alliance Laundry Systems for a list of ap-
proved PDAs and other external devices.
IR Communications Menu
Figure 1
The IR Communications Menu displays while the control is com-
municating with a PC/PDA. The control will jump back to the
previous page when the communication is complete.
Serial Card Reader Communications (Card Models
Only)
The control will accept communication with a serial card reader
in order to perform vending transactions when a card is inserted
to pay for cycles. The card reader can also allow the owner to
program a limited number of features and collect audit informa-
tion.
For detailed information on serial card reader communications,
refer to instructions included with card reader.
Network Communications
The control will also accept communication with a network inter-
face board which allows the control to be linked to a personal
computer. This network link allows an owner to program, collect
data and run diagnostics on any machine.
For detailed information on network communications, refer to the
network instructions.
USB Communications
The control has the ability to program and audit with a PC using
a USB connection between the control and a USB adapter don-
gle.
Preliminary Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
9
Part No. 806526ENR2
Содержание Quantum Platinum
Страница 2: ......
