Alliance Laundry Systems ZE1010-1502, Руководство по обслуживанию

Страница: 55 / 70

56
62631
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
61. TERMINAL BLOCK OR POWER CORD
a. Terminal Block – Electric Models (Refer to
Figure 38)
Through Serial No. S6270865XG:
(1) Remove access plate on rear of cabinet.
(2) Remove all wires from terminal block.
NOTE: Refer to appropriate wiring diagram when
rewiring terminal block.
(3) Remove screws holding terminal block to
bracket.
NOTE: Do not let terminal block insulation drop
when removing the block. Insulation must be in
place when reinstalling block.
Starting Serial No. S6270866XG:
(1) Remove two screws from the bottom edge
of the front panel. Refer to Figure 13.
(2) Swing the bottom of the panel away from
the dryer to disengage hold-down clips and
guide lugs from cabinet top. Refer to
Figure 13.
(3) Disconnect wires from door switch. Refer
to Figure 18.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
(4) Remove two cabinet hold-down screws.
Refer to Figure 14.
(5) Lift cabinet top to a vertical position by
hinging it on the rear hold-down brackets.
Refer to Figure 15.
NOTE: When servicing, cabinet top may be raised
and hinged on the rear hold-down brackets, or
supported against wall behind the dryer.
(6) Remove all wires from terminal block.
NOTE: Refer to appropriate wiring diagram when
rewiring terminal block.
(7) Remove screw holding terminal block to
bracket.
NOTE: Do not let terminal block insulation drop
when removing the block. Insulation must be in
place when reinstalling block.
b. Power Cord – Gas Models
(1) Remove access plate on rear of cabinet.
(2) Remove strain relief.
(3) Remove screw holding power cord ground
wire to terminal block bracket.
NOTE: Reconnect ground wire into same hole in
bracket when reinstalling power cord.
(4) Disconnect molex plug and remove power
cord from rear of dryer cabinet.
Figure 37
DRY866S
REAR
BULKHEAD
HEATER
BOX
ATTACHING
SCREWS
HEATER
BOX