Alliance Laundry Systems YT025E, Руководство по устранению неисправностей

Страница: 31 / 156

70380601
29
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 4
Adjustments
15. Loading Door Switch
The door switch should be adjusted so the
cylinder stops when door is opened 2 inches (51
mm), plus or minus 1/4 inch (6 mm). The switch
is normally open and is closed when the door is
closed. If adjustment is needed, proceed as
follows: Refer to
Figure 1 .
a. Close door and start tumbler. Slowly open
loading door. Cylinder and heat system should
shut off when door is open 2 inches (51 mm),
plus or minus 1/4 inch (6 mm).
b. Slowly close loading door. When door is 2
inches or less from being fully closed, the
switch actuator on the door should contact the
switch plunger and depress it enough to close
the switch with an audible “click”.
c. If switch actuator does not depress the switch
plunger enough to operate the switch, bend
switch actuator OUTWARD and repeat steps
“a” and “b.”.
16. Loading Door Strike
Refer to Figure 1 .
The door strike must be adjusted so that sufficient
tension holds loading door closed against the
force of a load tumbling against it. The door is
properly adjusted when 8-15 lbs. (3.60-6.75 kg)
of pull is required to open door.
If adjustment is needed, follow these steps:
a. Open loading door.
b. Loosen jamnut.
c. Turn door strike screw in or out as required.
d. Retighten jamnut.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
Figure 1
T280SE3C
Loading
Door
Jamnut
Door Strike
Screw
Switch
Actuator