Alliance Laundry Systems UL15F069, Руководство по установке и эксплуатации

Страница: 12 / 27

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
1800001
10
Pre-Installation Inspection
Upon delivery, visually inspect the packaging and
portions of the finisher that are visible through the
packaging for shipping damage.
If the package or finisher is damaged or if signs of
possible damage are evident, have the carrier note the
condition on the shipping papers before the shipping
receipt is signed, or advise the carrier of the condition
as soon as it is discovered.
IMPORTANT: Lift the box cover off the finisher
and check the items listed on the packing list.
Advise the carrier of any damaged or missing articles
as soon as possible. A written claim should be filed
with the carrier immediately if articles are damaged or
missing.
IMPORTANT: Warranty is void unless the finisher
is installed according to instructions in this manual.
Installation should comply with minimum
specifications and requirements detailed in this
manual and applicable local gas fitting regulations,
municipal building codes, water supply regulations,
electrical wiring regulations, and any other
relevant statutory regulations. Due to varied
requirements, applicable local codes should be
thoroughly understood and all pre-installation
arranged accordingly.
Location Requirements
It is strongly recommended that the purchaser be
present during installation and the first tests.
To assure compliance, consult and adhere to building/
local code requirements and comply with the
following:
●
The finisher must be installed in a very well
ventilated room (especially when using gas
heating) with correct lighting and an ambient
temperature in the range from 32°F (0°C) to
104°F (40°C).
●
Leveling should be carried out correctly on a hard
and stable floor surface, capable of supporting
the weight of the finisher. Contact your
mechanical engineer for foundation
requirements.
●
The finisher MUST NOT be installed or stored in
an area where it will be exposed to water and/or
weather.
IMPORTANT: DO NOT block the airflow at the
rear of the finisher with laundry or other articles.
Doing so would cause inadequate air supply to the
combustion chamber of the finisher.
Leave sufficient space around the finisher to allow for
correct functioning.
FOR FRONT RETURN MODELS ONLY:
●
Allow at least 4 inches (102 mm) in the back to
allow for ventilation.
●
Allow 32 inches (813 mm) on each side for
upkeep and maintenance.
●
Allow sufficient space in front so operator can
work efficiently and safely.
FOR REAR RETURN MODELS
●
Allow sufficient space in front and rear so
operator can work efficiently and safely.
To prevent fire, explosion, or personal
injury, this finisher may only be installed,
adjusted, and started up by qualified
technicians.
W678
WARNING