Alliance Laundry Systems LES37A*F, Инструкция по установке и эксплуатации

Страница: 16 / 34

Installation
510988
14 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Electrical Requirements
240 Volt, 60 Hertz, 2-Wire
Plus Grounded (Earth) Wire Installation
This dryer is designed to be operated on a two-wire
plus grounded (earth) wire, 240 Volt, 60 Hertz, single
phase supply circuit. It is designed to be fused at
30 Amperes. Consult nameplate for model and
electrical ratings.
NOTE: Branch circuit wire size requirements to
laundry room dryer outlet.
Use U.L. (Underwriters Laboratories) listed wire.
Allow sufficient slack in wiring so dryer can be moved
from its normal location when necessary.
1. Remove the screw and terminal block access
cover from the rear of dryer cabinet.
2. Insert ends of direct wire through power supply
hole (containing proper strain relief) in rear of
dryer cabinet. Connect the power cord, or direct
wiring,
to the two outer terminal block
terminals using the two wire-binding (10 - 32 x
3/8 inch) screws from the accessories pack in the
envelope shipped inside the dryer cylinder.
3. Attach ground (earth) wire to rear bulkhead as
shown.
IMPORTANT: Use only a U.L. listed No. 10
(copper wire only) two conductor power supply
cord kit rated 240 Volts (minimum) 30 Amperes for
electric dryers, and labeled as suitable for use in a
clothes dryer.
4. Tighten these wire-binding screws firmly.
IMPORTANT: Failure to tighten these screws
firmly may result in wire failure at the terminal
block.
5. Secure the strain relief to the power cord, or
wires, where they enter the dryer cabinet.
6. Reinstall access cover and screw.
Wire Length Electric Dryer
Less than 4.5 m
(15 ft.) 10 A.W.G.* Copper Wire Only
Longer than 4.5 m
(15 ft.) 8 A.W.G.* Copper Wire Only
To reduce the risk of fire, electric shock,
serious injury or death, the electrical
installation should conform to the National
Electrical Code, ANSI/NFPA 70, and such
local regulations as might apply.
W155
WARNING