Alliance Laundry Systems LEB07A*-1709, Руководство по обслуживанию

Страница: 36 / 75

505033
35
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
38. LIMIT THERMOSTAT (Gas Models)
a. While supporting the access panel, remove two
screws from bottom edge of access panel. See
Figure 6.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. See
Figure 13.
c. Disconnect wires and remove screws attaching
limit thermostat to burner housing or element
plate. See Figure 17.
d. Repeat procedure on models with more than
one thermostat.
39. HEATING ELEMENT (Electric Models)
a. While supporting the access panel, remove two
screws from bottom edge of access panel. See
Figure 6.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. See
Figure 13.
c. Disconnect wires from element and plate. See
Figure 17.
d. Remove two screws holding element and plate
to heater box and remove element and plate out
through front of dryer. See Figure 17.
NOTE: When reassembling, be sure all wire
connectors are tight on element terminals, thermal
fuse and limit thermostat.
40. THERMOSTAT AND HEATER
a. While supporting the access panel, remove two
screws from bottom edge of access panel. See
Figure 6.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. See
Figure 13.
c. Disconnect wires and remove thermostat
attaching screws, thermostat and heater. See
Figure 18.
Figure 18
ATTACHING
SCREWS
SEAL
WIRE
HARNESS
THERMOSTAT
AND HEATER
D324SE3A