Cooldown Function
Automatic Cooldown
• This function avoids thermal shock in the washing machine.
• For Hot washes above 149°F [ 65°C], Cold water is added at
the end of the step.
Programmed Cooldown
• This function is recommended to avoid the shrinking of the
garments.
• Water is drained and cold water is added bit by bit. The tem-
perature of the water in the tub will decrease slowly as a func-
tion of the programmed Cooldown Sequence (temperature
and time).
Spray Function
• The special product is injected while the drain valve is open
and depending the programmed speed, the drum will spin at
distribution or low spin speed.
Unbalance
• When the machine is badly loaded during the spin sequence,
then the safety switch or the overweight detection system will
get activated.
• The spin sequence will be interrupted and the garments in the
drum will be redistributed.
• The washing machine will try up to 5 times to redistribute the
garments.
Adding Detergents
• When a signal Pause has been programmed, at the end of a
wash sequence, the machine will stop the Program and the
message "Pause, Press Start to Continue" will be displayed.
• The buzzer will give a warning for the operator.
• Now the operator can add Soap.
• By pressing the START button the PROGRAM will go on
with the next Program step.
Wait State
• It can occur that the normal machine operation has been inter-
rupted and that you have to wait until the Wash Computer al-
lows you to go on.
• You can recognize the wait state by a display that shows
WAIT and a decreasing counter.
• This will occur when the power has been switched off and on
at a running wash cycle.
• As the software doesn‘t know how fast the motor was spin-
ning, a delay time is respected before the machine can be re-
started.
How to Handle Failure Messages
• When a failure has been detected by the Wash Computer, a
failure message is generated to inform the operator about the
problem.
CFD1428R_SVG
Ou t O f Order (Pr: XX St : YY)
Ask For Se rvice
(Err ZZZ : Fau lt Mes sage )
XX : The Program number
YY : The Step number
Err ZZZ : The error number
Fault Message : The name of the error message
Figure 25
• At the upper line, the program number and step number of the
interrupted program are displayed.
• The message UNLOAD! will inform you if it‘s allowed to
open the door.
Safety Conditions
• If there is still water in the drum or if the temperature is too
high, it‘s not possible to open the door.
• The messages "WATER IN CAGE" or "TOO HOT" will be
displayed together with the level and the temperature.
WARNING
It’s up to the operator to take the necessary precau-
tions if the drain valve is not functional and there is
still hot water in the tub at the end of the wash cycle.
On the display the actual water temperature and lev-
el will be displayed. Wait until the water is drained
and until the water has cooled before all interven-
tions as hot water can cause burns.
C069
• If something goes wrong with the door lock, the program will
be finished immediately.
• For safety purposes, the door will stay locked.
WARNING
Go to the chapter Troubleshooting to find out more
about error handling.
C070
Operation Menu
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
61
Part No. D1631ENR7
Содержание IYG065J
Страница 2: ......
