Alliance Laundry Systems FES17AxF, Сервисная инструкция

Страница: 44 / 82

42
512261
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
46. HEATER ASSEMBLY (Electric Models)
a. While supporting access panel, remove two
screws from bottom edge of access panel. Refer
to
Figure 8 .
b. Gently lower access panel to disengage locators
from bottom edge of front panel. Refer to
Figure 17 .
c. Remove two screws holding heater assembly to
heater box and remove heater assembly out
through front of dryer. Refer to
Figure 21 .
d. Disconnect wires from heater assembly. Refer
to Figure 21 .
NOTE: When reassembling, be sure all wire
connectors are tight on element terminals, thermal
fuse and limit thermostat.
47. THERMOSTAT
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to
Figure 8 .
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to
Figure 17 .
c. Disconnect wires and remove thermostat
attaching screws. Refer to Figure 22 .
48. AIR DUCT
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to
Figure 8 .
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to
Figure 17 .
c. Open loading door and remove screw from end
of lint filter. Refer to Figure 12 .
d. Lift lint filter out of air duct, paying close
attention to orientation.
Figure 22
Attaching
Screws
Seal
Thermostat
Ground
Screw
Wire
Harness
D400SE1F
Ground
Wire
Figure 23
D307SE1D
Front
Bulkhead
Front
Air Duct
Lint
Filter
Screw