Alliance Laundry Systems FES17AxF, Сервисная инструкция

Страница: 32 / 82

30
512261
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
30. ACCESS PANEL
Refer to Figure 8 .
a. While supporting access panel, remove two
screws from bottom edge of panel.
b. Gently lower access panel to disengage panel
locators from bottom edge of front panel.
c. Remove access panel.
31. CABINET TOP
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to
Figure 8 .
b. Gently lower access panel to disengage panel
locators from bottom edge of access panel.
Refer to
Figure 17 .
c. Remove two screws holding bottom tabs on
front panel to dryer cabinet. Refer to Figure 9 .
d. Swing bottom of front panel away from dryer to
disengage hold-down clips and locators from
cabinet top.
e. Disconnect wires from door switch. Refer to
Figure 16 .
NOTE: Refer to wiring diagram when rewiring
switch.
f. Remove two screws holding cabinet top to front
flange of cabinet. Refer to Figure 10 .
g. Lift cabinet top to a vertical position by hinging
it on the rear hold-down brackets. Refer to
Figure 11 .
NOTE: While servicing, cabinet top may be raised
and hinged on the rear hold-down brackets or
supported against wall behind dryer.
h. Rear Control Models:
Carefully withdraw wire harness through hole
in cabinet top and lift the top off the hold-down
brackets. Refer to
Figure 11 .
Figure 8
Access
Panel
Panel
Attaching
Screws
D302SE3B
Figure 9
DRY1817S
Front Panel
Attaching
Screws