Alliance Laundry Systems BWNBC2PP112TW01, Программирование

Страница: 21 / 28

Default Cycle
dCyC
This option allows the owner to set the default cycle type.
1. Control must be in Manual Mode. Refer to
How to Enter the
Manual Mode .
2. Press the PERM PRESS/WARM (
∧
) or the DELICATES/
COLD (
∨
) keypad until
PrOg
appears in the Four-Digit Dis-
play.
COM1R_SVG
Figure 21
3. Press the START (enter) keypad and
AtS
will appear in the
Four-Digit Display.
4. Press the PERM PRESS/WARM (
∧
) or the DELICATES/
COLD (
∨
) keypad to scroll through the programmable options
until
dCyC
appears in the Four-Digit Display.
TLW1944N_SVG
Figure 22
5. When
dCyC
appears in the Four-Digit Display, press the
START (enter) keypad. A letter code will appear in the Four-
Digit Display. This code (found below) corresponds to the cy-
cle type.
hEAy
= NORMAL/HOT
nOrL
= NORMAL/WARM
PP
= PERM PRESS/WARM
dEL
= DELICATES/COLD
6. Press the PERM PRESS/WARM (
∧
) or the DELICATES/
COLD (
∨
) keypad to increase or decrease the current code
displayed in the Four-Digit Display to the desired code.
7. Press the START (enter) keypad when the correct code ap-
pears in the Four-Digit Display.
NOTE: To program other options, refer to the appro-
priate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
21 Part No. 202713ENR1