Alliance Laundry Systems BFNBCASG113TN01, Оригинальное руководство пользователя

Страница: 15 / 51

Opening the Service Door
Stacked Washers and Dryers, 10
Degree Front Control Washers and
Coin Rear Control Washers
Models through Serial No. 1810000001
Manual programming requires the user to open and close the
service door. Opening and closing the service door trips a switch
allowing access to various programming options, diagnostics, and
audit capabilities. On coin models, the coin vault switch must be
closed to enter Manual Mode.
Models starting Serial No. 1810000001
Manual programming requires the user to unplug the bullet con-
nector located between the “white/black” and “red/blue” wires.
Reconnect the connector for normal operation.
After opening and closing the service door or unplugging the bul-
let connector, the programmer has 4.25 minutes to begin pro-
gramming. If a keypad has not been pressed in that time, the con-
trol will revert back to the Ready Mode. Refer to
Figure 2 .
The service door is located in the control panel on the Stacked
Washer and Dryers and Front Control Washers. On Rear Control
Washers, the service door is located on the top of the meter case.
Refer to
Figure 2 .
Rear Control Washers with Card Reader
Manual programming requires the user to remove the control
panel and unplug the bullet connector located between the
“white/black” and “red/blue” wires. This will allow the user to
access various programming options, diagnostics, and audit capa-
bilities. Refer to
Figure 2 .
Opening the Service Door
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. 805407R6