Allen-Bradley SLC 500 DeviceNet, Руководство пользователя, Страница: 69 / 139

1 Publication 1747-6.5.5 - August 2000
Chapter
5
Communicating with DeviceNet
from Another Network
What This Chapter Contains This chapter describes how to communicate with the DeviceNet
network from another network, using the SLC 500 “pass-through”
feature. This feature can be used to adjust and fine tune the nodes on
your network. Examples are provided for communicating from an
Ethernet network and a Data Highway Plus network.
The following table describes what this chapter contains and where to
find specific information.
ATTENTION
!
The pass-through feature is not intended to replace a
1770-KFD, PCD, PCID, or PCIDS connection to the
network:
•
Pass-through is intended only for fine tuning and
adjustment of your network devices. Do not
attempt to configure your entire network using a
pass-through driver or a time-out may occur.
•
The pass-through method is not suitable for real
time monitoring of your network devices.
For information about See page
Where to Find More Information 5-2
System Requirements 5-2
Communicating with DeviceNet via an Ethernet Network 5-3
Configuring the DeviceNet Pass-Through Driver 5-6
Communicating with the DeviceNet Network 5-9
Communicating with DeviceNet via a DH+ Network 5-12
Configuring the DeviceNet Pass-Through Driver 5-12
Communicating with the DeviceNet Network 5-15