Rockwell Automation Publication 750-IN020D-EN-P - May 2017
3
PowerFlex 755 IP00, NEMA/UL Open Type Drive
Personal Safety (continued)
Product Safety
Class 1 LED Product
Certifications
See the PowerFlex 750-Series AC Drives Technical Data, publication
, for detailed specifications and certifications.
ATTENTION:
Hazard of personal injury or equipment damage due to
unexpected machine operation exists if the drive is configured to automatically
issue a Start or Run command. Do not use these functions without considering
applicable local, national and international codes, standards, regulations or
industry guidelines.
ATTENTION:
An incorrectly applied or installed drive can result in component
damage or a reduction in product life. Wiring or application errors such as under
sizing the motor, incorrect or inadequate AC supply, or excessive surrounding air
temperatures may result in malfunction of the system.
ATTENTION:
This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing, testing,
servicing or repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with static control
procedures, reference Guarding Against Electrostatic Damage, publication
8000-4.5.2 or any other applicable ESD protection handbook.
ATTENTION:
Configuring an analog input for 0-20 mA operation and driving it
from a voltage source could cause component damage. Verify proper
configuration prior to applying input signals.
ATTENTION:
A contactor or other device that routinely disconnects and
reapplies the AC line to the drive to start and stop the motor can cause drive
hardware damage. The drive is designed to use control input signals that will
start and stop the motor. If an input device is used, operation must not exceed
one cycle per minute or drive damage will occur.
ATTENTION:
Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber optic cable connectors.
IMPORTANT
To meet UL certification, the Field Termination and Control Pod kits described
on
must be used.
