Allen-Bradley micrologix 1500, Руководство пользователя

Страница: 31 / 149

Publication 1764-UM001A-US-P
Installing Your Controller 2-15
Installing Controller
Components
Prevent Electrostatic Discharge
Processor
1. Be sure base unit power is off.
2. Slide the processor into the base unit using the guide rails for alignment.
3. Push until a click is heard.
ATTENTION
!
Electrostatic discharge can damage integrated circuits or
semiconductors if you touch bus connector pins. Follow these
guidelines when you handle any module:
•
Touch a grounded object to discharge static potential.
•
Wear an approved wrist-strap grounding device.
•
Do not touch the bus connector or connector pins.
•
Do not touch circuit components inside the module.
•
If available, use a static-safe work station.
When not in use, keep the module in its static-shield bag.
ATTENTION
!
Be sure the base unit is free of all metal fragments before
removing protective debris strips and installing the processor
unit. Failure to remove strips before operating can cause
overheating.
IMPORTANT
It is critical that the processor is fully engaged and locked into
place.
AB Spares