Allen-Bradley Kinetix 350, Руководство пользователя

Страница: 82 / 162

82 Rockwell Automation Publication 2097-UM002D-EN-P - April 2017
Chapter 5 Configure and Start up the Kinetix 350 Drive System
By accessing these four parameters, the full IP address on the drive can be
obtained.
If parameters IP_1, IP_2, IP_3, and IP_4 all contain ‘----‘ rather than a
numerical values it means that the drive has DHCP enabled and the DHCP
server has yet to assign the drive its dynamic IP address. As soon as server
assigns an IP address the drive displays the address in the IP_1, IP_2, IP_3, and
IP_4 parameters. See Configure the IP Address Automatically (Dynamic
Address) on
page 83 .
Configure the IP Address Manually (Static Address)
When connecting directly from the Kinetix 350 drive to the personal
computer without a server or when connecting to a private network, where all
devices have static IP addresses, assign the IP address of the Kinetix 350 drive
manually.
To assign the address manually, disable the DHCP mode. Do following the
steps by using the drive keypad.
1.
Press .
2.
Use to access parameter DHCP.
3.
Check that this parameter is set to a value of 0.
4.
If the DHCP parameter is set to 1, then use and to set to 0.
5.
Cycle power to the drive.
The change takes effect.
When DHCP is disabled and the power is cycled to the drive, it reverts to its
previous static IP address.
If you are connecting multiple drives to the personal computer, create unique
IP address for each drive. Do it by using the keypad on each drive to change the
IP_4 parameter. IP_4 is the only octet that can be changed via the keypad.
IP_1, IP2, and IP_3 are read-only accessed this way. The dive power must be
cycled for any changes to take effect.