Allen-Bradley armorstratix 5700, Руководство пользователя, Страница: 158 / 458

158 Rockwell Automation Publication 1783-UM007I-EN-P - December 2017
Chapter 3 Configure Switch Features
Motion Prioritized
QoS Macros During Express Setup, the switch applies QoS settings optimized for most
applications. The default QoS settings assign equal priority to traffic for CIP
and traffic for integrated motion on the EtherNet/IP network. However, you
can assign the highest priority to traffic for integrated motion on the
EtherNet/IP network by applying the following QoS macros in
Device Manager.
These macros move motion traffic to the highest level queue with time sync.
After you apply the macros, motion traffic takes priority over CIP traffic.
Configure Motion Prioritized QoS Macros via Device Manager
From the Configure menu, choose Global Macros:
•
To apply a macro, check the checkbox for the macro and click Save.
•
To remove a macro, clear the checkbox for the macro and click Save.
Once you click Save, the changes take effect immediately.
Table 61 - Motion Prioritized QoS Macros
Switch Macro
Stratix 5400 Motion Prioritized QoS
Stratix 5410
Stratix 5700 Motion Prioritized QoS Step 1
Motion Prioritized QoS Step 2
ArmorStratix 5700
Stratix 8000
IMPORTANT For Stratix 5700 and 8000 switches, you must apply both Motion Prioritized
QoS Step 1 and Motion Prioritized QoS Step 2
macros. If you enable only one
macro, the QoS settings applied during Express Setup remain active.
Stratix 5400 and 5410 Switches
Stratix 5700, ArmorStratix 5700, and Stratix 8000 Switches