Manual
SmartHandle AX
42 / 55
SimonsVoss
11 | Battery replacement
11 Battery replacement
11.1 Instructions on battery replacement
–
Only specialists may replace the batteries.
–
Do not touch electronics/components; do not allow them to come into
contact with oil, paint, moisture, alkali or acids.
–
Only use batteries approved by SimonsVoss.
–
The batteries used may pose a fire or burn hazard if handled incorrectly.
Do not recharge, open, heat or burn these batteries. Do not short-
circuit!
–
Dispose of old or used batteries correctly. Store out of children's reach.
–
Check the polarity of the batteries.
–
The batteries will have discharged to roughly the same level. That is
why you must replace all batteries.
–
Do not touch the contacts on the new batteries with your hands when
replacing the old ones. Use cotton gloves free of fat or grease.
–
When replacing the batteries, make sure that no pressure is applied to
the electronics or that they are not damaged in any other way.
11.2 Procedure
The batteries are located beneath the inlay in SmartHandle AX. You need
the SimonsVoss installation tool to replace the batteries.
1. Insert the SimonsVoss installation tool in the designated slots in the
inlay to open. The slots are located on the side facing away from the
electronics.