InstAlert 18 Quick Start Guide
Thank you for purchasing an All Traffic Solutions InstAlert 18 Variable Message Sign. This
Quick Start Guide will show you how to set up, power, and configure your new sign. If you
have a TraffiCloud subscription, you can log on to TraffiCloud to set up your signs remotely.
Non-subscribers can complete sign setup locally. See
Step 4: Configure the InstAlert 18 locally
[Figure 1] InstAlert 18 Variable Message
Sign
Step 1: Unpack the equipment
Remove the sign, batteries, charger, and other optional equipment
from the boxes.
Batteries should be fully charged before deployment. InstAlert Variable
Message Signs can accommodate up to two 16Ah lithium batteries
internally. Although only one battery is required, two batteries are
recommended to extend the run time of the sign, on average from 7 to
10 days.
For all steps involving batteries, repeat for the second battery as
necessary.
To remove the batteries:
A. Place the InstAlert 18 face down on a flat surface and remove the
mounting bracket by unlocking the lock with the supplied key
and lifting up on the bottom of the mounting bracket.
[Figure 2] Slide the battery
[Figure 3] Disconnect/connect
the battery
B. Next, remove the battery compartment cover by removing the thumb screws. Set the key, bracket, and thumb
screws aside.
C. Slide the battery out of the battery compartment, as shown in
.
D. Disconnect the connectors, as shown in
.
Step 2: Charge the batteries
The InstAlert 18 arrives with the batteries partially charged and needs to be fully charged before deployment.
W
ARNING
:
RISK OF ELECTRIC SHOCK AND DAMAGE TO EQUIPMENT The charger is not intended for
outdoor use. Only charge and store the batteries in a controlled environment.
ATS | Chantilly, VA | United States | Tel: 1-866-366-6602 | Email:
| Web:
Copyright © 2022 | All Traffic Solutions, Inc.® | Document ver.1.01 | All rights reserved.
