HARDWARE
1 ¾" Screw…38
2 ½" Screw…12
4" Screw…4
Carriage Bolt…4
Hex Nut…4
Washer…4
Rocker Instructions
(
RC22U unassembled kit
)
Tools Required: #2 Philips Drive, #2 Square Drive, Wood Glue.
( Its recommended wood glue be used on all dowel joints)
Step 1. Layout Parts
•
Layout all parts as seen in the parts diagrams above.
Step 2. Build Rocker/Arm Assembly
•
Position short leg near front of arm and long leg near rear of arm.
Attach the legs to the arms using dowels and 2-1/2 inch screws.
•
Position rocker over leg assembly so that front (shorter) leg
is nearest to front of rocker, attach using 4 inch square drive screws.
Step 3. Build Seat Assembly
•
Place sides approximately 21-1/4 inches apart.
•
Attach front scallop using 1 ¾ inch screws.
•
Place a seat slat so it overlaps front scallop and attach.
•
Attach remaining seat slats + 1 rear cove slat with 1 ¾ inch
screws. Leave no spacing between slats - fit tight together.
PARTS:
(a)
2 arms
(b)
2 rockers
(c)
2 front leg
(d)
2 back leg
(e)
2 back supports
(f)
2 struts
(g)
7 back slats
(h)
2 sides
(i)
1 front scallop slat
(j)
5 seat slats
(k)
1 rear cove slat