Adirondack Chair Instructions
(
AA21U unassembled kit
)
Step 1. Layout Parts
•
Lay out all parts as seen in parts diagram above
Step 2. Build Back Assembly
•
Place top and bottom back brace approximately 18-½ inches apart –
curved side up.
•
Lay back slats in curved section of braces spaced at equal distances
apart. Attach using 1-3/4 inch screws.
•
Attach the end slats first - then the center slat - followed by the
remaining slats.
Hardware:
1-1/2 inch screw...16
1-3/4 inch screw…48
Carriage bolt…2
Washer…2
Hex nut…2
(A) 1 bottom back brace
(B) 7 back slats
(C) 1 top back support
(D) 2 back struts
(E) 1 front scallop slat
(F) 6 seat slats
(G) 2 sides
(H) 2 front legs
(I) 2 support blocks
(J) 2 arm paddles
Tools Required: #2Philips or Robertson screwdriver, and a ½ inch wrench.
