Alinket
ALXB10x User Manual
Alinket Electronic Technology (Shanghai) Co.,Ltd.
All rights reserved. E-mail
：
Appendix A: Frequently Asked Questions and
Answers
Q:
What are the working modes of ALXB10x?
A:
The working modes of ALXB10x are Station mode and AP mode, the Station mode is the
user's service data transmission channel. After connecting with the customer
’s device, ALXB10x
and the customer’s device can connect to the wireless router as a whole; The AP mode is
ALXB10x's own configuration channel, which acts as an access point to the wireless LAN, used
for wireless access of computers with the ALXB10x Configuration Tool. By default, the two
working modes of alxb10x coexist at the same time. User can also turn off the AP mode
separately, and use Station mode only, as shown
Q:
When wireless configuration mode is used, computer with ALXB10x Configuration Tool
cannot find Soft AP of ALXB10x.
A:
The following checks may solve this issue
：
1) Check the network cable connection between ALXB10x and the customer's device.
2)
The SSID started by ALXB10x is hidden by default, and it needs to be “entered
manually”.
3) If ALXB10x has ever been connected to a wireless router, the frequency band and
channel of the soft AP of ALXB10x are consistent with the target router;
If ALXB10x has not been connected to any external router, then the frequency band and
channel of AP broadcast is channel 2 in 2.4Ghz by default.
Q:
After 5G is configured successfully, the soft AP triggered by B10 cannot be found.
A:
Since ALXB10x has been connected to 5G router, the band of soft AP is 5G as well. It is
necessary to check whether the PC with ALXB10x Configuration Tool supports 5G Wi-Fi
function.
Q:
When ALXB10x is in the process of connecting to target router, the status indicator flashes in
red and blue alternatively, and the ALXB10x cannot connect to the network.
A:
It is because the network cable connection between ALXB10x and the customer device is
disconnected. No need to re-configurate or reset ALXB10x. This issue can be solved after
the network connection is restored.
Q:
After AP parameter configuration, status indicator flashes in blue, the device connected with
ALXB10x is unable to access the internet.
A:
It is possible that the AP parameters configured through ALXB10X Configuration Tool is
wrong. Please check the configuration information including SSID, encryption mode, and
password. You can use the ALXB10x Configuration Tool to read and reconfigure the above
information for ALXB10x. If the above information is configured correctly and the status
indicator continues to flash in blue, please check whether the target router is working
properly.
Q:
During the process of connecting ALXB10x to the target wireless route, if user want to modify
the parameters of ALXB10x by wireless configuration mode again, it is found that the
computer could not connect to the soft AP of ALXB10x.
