19
6.23.Tx Interrupt
This feature allows the supervisor to start the transmission while another person is
talking. It allows supervisor to override the ongoing transmission brings other radios
hear what the supervisor is saying, the radio that is transmitting at the time of this
override will not hear the supervisor until he release keys his radio and then he will be
able to hear the rest of the conversation.
7.Channel Setting (Available in Analog Channel only)
When the channel type is analog, it will automatically hide the digital menu, the below
listed menus are for analog channel only, unlisted menus are the same as the digital
channel, please refer to Chan Set (Digital Channel).
7.1. New Channel
Radio allows to create a new channel and save current set up to the new channel.
1.Select "New Chan", then input new channel number and confirm.
2.Input channel name and confirm.
3.Select a zone and confirm. The new channel will be saved to the selected zone7.2.
Delete Channel
7.2.Delete Channel
Allows to delete current channel.
1.Select "Delete Chan", the radio will remind " Delete? "
2.Press confirm key, the current channel will be deleted.
Note: After delete one channel, the radio will move to next channel.
7.3. Channel type
A-Analog : Set up the current channel to analog channel.
D-Digital : Set up the current to digital channel
A+D TX A: Mixed analog, allow receive analog and digital signal, TX is analog.
D+A TX D: Mixed digital, allow receive analog and digital signal, TX is digital.
7.4.TCDT
7.5.RCDT
7.6.RTCDT
Set up the CTCSS/DCS code for both TX and RX CTCSS code: 62.5Hz~254.1Hz, a
total of 51 groups DCS code: 000N~7771, a total of 1024 groups.
7.7.Optional Signal
Allows the setup of DTMF/5TONE/2TONE encode and decode for the Analog
channels.
7.8.TX Power
Set up the TX power levels for current channel.
7.9.Offset
Press [UP]/ [DOWN] key to adjust transmission offset frequency. When “offset” is
activated when transmit the TX frequency will be offsetted.
7.10.Squelch mode
When the analog channel is set up for both CTCSS/DCS decoding and optional
signaling, you can set up the RX condition in this menu.
SQ: You can hear the call once the channel receive matched carrier. CDT: You can hear
the call when receive matched CTCSS/DCS signal. TONE: You can hear the call when
