Alimak Scando 650 DOL, Техническое описание

Страница: 10 / 148

Hoist mast
The square mast c/c 650 x 650 mm (2’- 1 1/8’’ x 2’- 1 1/8’’) is
the mainstay of the SCANDO 650 access system. The mast is
constructed of tubes and frames of high tensile steel and
fabricated in lenghts of 1508 mm (4’- 11 3/8’’). Each section is
provided with one or two bolted rack(s) module 5 and the
sections are bolted together with bolts and nuts.
The four guiding tubes and possibilities with two racks give
dual car set up advantages. Counterweight guide rail can be
bolted to all mast sections.
The ties are attached to the frames of the mast sections or alt. to
the rear mast tubes. The other end to special brackets attached
to the wall. The tie length is telescopic adjustable within
different intervals. The ties can also be inclined from the
horizontal. Specifications for each particular mast tie can be
found in chapter H.
Mast sections and mast ties are hot dipped galvanized with the
exception of the mast section rack.
Wall bracket bolt dimension is M24
A
4
Counterweight
guide rail
Corresponding wall
bracket can be installed
either on slab ...
a 210
... or against wall
ALIMAK 34742 - 1/02
Alimak original dia. 76 mm
pivoted tube coupler