Alimak Scando 650 DOL, Техническое описание

Страница: 28 / 148

Allowable freestanding heights when using pre-fabricated
sheet steel foundation
Hoist installed on a sheet steel foundation (1 pce) or on two (2
pcs) sheet steel foundations bolted together on top of the other
can be erected and used with freestanding mast heights accor-
ding to the following table based on car length and maximum
allowable payload.
Methods to increase the freestanding mast height
Tubes connected to the steel sheet foundation and assembled
with tube couplers to the mast tower’s rear mast tubes, up to the
6 meters’ (20 ft.) level, will allow mast heights according to the
following table based on car length and maximum allowable
payload.
Reinforcement tubes dia. 76 mm are 3 (10 ft.) meter in length.
Two pair of tube couplers are used on each mast section.
Car length Payload Freestandig During
in operation erection*
Hoist installed on 2 pce steel sheet foundation
3.2 m (10’- 6’’) 2000 kg (4400 lbs.) 22.5 meter, zone C
3.9 m (12’- 9 1/2’’)
4.6 m (15’- 1’’)
A
22
ALIMAK 34760 - 1/01
Car length Car payload Freestandig in opeartion During erection*
capacity Single car Dual cars Single car
Hoist installed on 1 pce steel sheet foundation
3.2 m (10’- 6’’) 2000 kg (4400 lbs.) 13.5 meter (45 ft.), zone C 24 meter (79 ft.)
2000 kg (4400 lbs.) 12 meter (40 ft.) zone D
3.9 m (12’- 9 1/2’’)
4.6 m (15’- 1’’)
Hoist installed on 2 pcs steel sheet foundations bolted together
3.2 m (10’- 6’’) 2000 kg (4400 lbs.) 15 meter (50 ft.), zone C 24 meter (79 ft.)
2000 kg (4400 lbs.) 13.5 meter (45 ft.), zone C
3.9 m (12’- 9 1/2’’)
4.6 m (15’- 1’’)
* Maximum allowed freestanding with load reduced to maximum 8 pcs mast sections and 2 people in the car
v (1160 kg) and wind speed less than 12.5 m/s.