34 | Setting up the monitor
13.
Slide the tabs on the I/O cover into the slots on the display back cover until
it snaps into place.
NOTE: Ensure that all cables pass through the I/O cover and cable-
management slot on the stand riser.
Connecting the computer
WARNING: Before you begin any of the procedures in this section,
follow the
NOTE: Do not connect all the cables to the computer at the same time.
NOTE: The images are for the purpose of illustration only. The
appearance of the computer may vary.
To connect your monitor to the computer:
1.
Connect the other end of the DisplayPort-DisplayPort/USB-C-
DisplayPort/HDMI cable to your computer.
2.
Connect the other end of the USB 3.2 Gen 1 upstream cable to an
appropriate USB 3.2 Gen 1 port on your computer.
3.
Connect the USB peripherals to the SuperSpeed USB 5 Gbps (USB 3.2
Gen 1) downstream ports at the bottom of the monitor.
4.
Plug the power cables of your computer and monitor into a wall outlet.
5.
Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not
display an image, see
.