30 | Setting up the monitor
Setting up the monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the setup instructions that are
included with the stand.
CAUTION: The following steps are important to protect your curved
screen. Follow the instructions to complete the installation.
1.
Remove the stand riser, stand base, and I/O cover from the packaging
cushion.
NOTE: The images are for the purpose of illustration only. The
appearance of the package cushion may vary.
2.
Align and place the stand riser on the stand base.
3.
Open the screw handle at the bottom of the stand base and turn it
clockwise to secure the stand assembly.
4.
Close the screw handle.
