Setting up the monitor | 31
Setting up the monitor
Attaching the stand
NOTE: The stand is not factory-installed.
NOTE: The following instructions are only applicable for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the setup instructions that were
included with the stand.
CAUTION: The following steps are important to protect your curved
screen. Follow the instructions to complete the installation.
1.
Remove the stand riser, stand base, I/O cover, and VESA adapter from the
packaging cushion.
NOTE: The graphics are used for illustration purposes only. The
appearance of the package cushion may vary.
2.
Align and place the stand riser on the stand base.
3.
Open the screw handle at the bottom of the stand base and turn it
clockwise to secure the stand assembly.
4.
Close the screw handle.
