Steps
1.
Align the screw holes on the power-button module with the screw holes on the front bezel.
2.
Replace the two screws (M2x4) that secure the power-button module to the front bezel.
3.
Connect the cables to the power-button module.
Next steps
1.
.
2.
.
3.
.
4.
.
5.
Follow the procedure in
After working inside your computer
.
System board
Removing the system board
Prerequisites
1.
Follow the procedure in
Before working inside your computer
NOTE: Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS
setup program after you replace the system board.
NOTE: Replacing the system board removes any changes you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you
can reconnect the cables correctly after you replace the system board.
2.
.
3.
4.
5.
6.
processor liquid-cooling assembly
processor fan and heat-sink assembly
7.
, as applicable.
86
Содержание Aurora R9
