Removing the Side Panels
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before Working Inside Your Computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
NOTE: Make sure that you remove the security cable from the security cable slot (if applicable).
1. Remove the screw that secures the security-cable slot latch.
The security-cable slot slides to the unlocked position.
2. Lift the release panel to open the right side-panel.
3. Pull and lift the right side-panel away from the chassis.
1. screw
2. security-cable slot latch
3. release panel
4. right side-panel
4. Repeat the procedure from step 2 to step 3 on the left side-panel.
19
Содержание Area-51 ALX
