1
www.observint.com
ALI-NS3014R_CQ
10/13/15
Step 1. Install the camera
1.
Determine the best fasteners for securing the camera to mounting surface. The mounting hardware
provided is suitable for most surfaces.
2.
Using the Drill Template provided, mark the location of the mounting screw holes. If the drop cable
will be routed through the mounting surface, mark the location of the hole for the cable.
NOTE
: The
drop cable can be routed through the cable channel on the side of the base.
3.
Drill holes for the mounting fasteners, and for the drop cable if needed.
4.
Route the drop cable as planned, then secure the mounting base to the surface with the fasteners.
5.
Wire the ground terminal on the back of the camera to an earth grounded conductor.
Step 2. Connect the camera to the LAN and power it on
1.
Route a Ethernet LAN cable to the camera and plug it into the Ethernet connector. Seal the
connection from moisture and other contamination. A weatherproof fitting is provided.
Ethernet connector
Drop cable
12 Vdc Power
connector
If the camera is powered through the LAN cable (PoE), apply power to the cable to power on the
camera, then continue to “Step 3. Install the Alibi Discovery Tool” on page 4
2.
Route a 12 Vdc power cable to the camera and connect it to the 12 Vdc connector on the camera
drop cable. The polarity of the drop cable connector is shown below.
CAUTION
Before applying power to the camera, ensure that the polarity is correct. An incorrect connection
may cause a malfunction and can damage the camera.
Seal the power cable connectors as needed from moisture and other contamination.
Apply power to the cable to power on the camera.
Step 3. Install the Alibi Discovery Tool
Alibi Discovery Tool is a software utility used to “discover” Alibi cameras and NVRs/DVRs installed on the
physical Ethernet network (LAN) and change their network settings. Discovery Tool is provided on the CD
with your camera and is contained in Alibi Power Tools. To use Discovery Tool:
1.
Insert the software CD provided with your camera into an optical drive on the Microsoft Windows
computer you will use to access your camera on the LAN.
2.
On the CD, find the folder that contains the Alibi Power Tools (Alibi Tools Utility).
3.
Install Alibi Power Tools. Refer to the
ALIBI™ Power Tools Installation and User Manual
also provided
on the CD. When the program opens, the following screen appears.
ALI-NS3014R 4.0 MP IP Bullet
Camera Quick Installation Guide
This document guides you through the basic steps to install and configure the ALI-NS3014R camera. For
more information about the features of these cameras, please refer to the
ALIBI IP Camera Software V2
User Manual
.
Features
•
4 Megapixel CMOS progressive scan sensor
•
High definition video streaming up to 2688 x 1520 pixels with Dual-stream video support
•
Video stream compression using H.264 standard
•
3D-DNR noise reduction and Wide Dynamic Range (WDR)
•
Backlight compensation
•
IR sensors for night vision
•
Dual power capable - Power over Ethernet (PoE) or 12 Vdc
•
Weatherproof - IP66 rated
Sun shield adjustment screw
Sun shield
IR array
Lens
Ground terminal
Reset button
(recessed)*
Cable channel
Drop cable
Adjustable bracket
lock nut
Adjustable bracket
Mounting base
* To reset the camera to its factory state, press and hold the reset button for 10 seconds during reboot or power on.
What’s in the box
The box contains this document with the items shown below.
Drill Template
Documentation and
Installation Tool CD
Weatherproof fitting
for Ethernet cable
Mounting screws
and wall inserts
