25
It worked for a
couple of minutes
but then it turned
off.
1. The ignition phase is not over.
2. Check if there is an electricity interruption.
3. The smoke channel is clogged.
4. Interference of failure of the pressure switch.
5. The spark plug is damaged.
1. Try igniting again.
2. See last instruction.
3. The smoke channel is clogged.
4. Check or change the probe.
5. Check or change the spark plug.
Wooden granules
are settling in the
combustion
chamber.
The glass on the
door is dirty and
the flame is weak.
1. Lack of air for combustion.
2. Wet or inadequate wooden granules.
3. The smoke vacuum system motor is defective.
1. Clean the combustion chamber and check if all
the openings are clear. Do the standard cleaning of
the combustion chamber and the smoke channel.
Check if air flow is clogged. Check the gaskets on
the door.
2. Change the type of the wooden granules.
3. Check the motor and change if needed.
The smoke
vacuum motor is
defective.
1. The stove is not receiving the electricity.
2. The motor is defective.
3. Motherboard is defective.
4. The control panel is defective.
1. Check the main power supply and resistance to
melting.
2. Check the motor and condenser; change if
needed.
3. Change the electronic card.
4. Change the control panel.
In automatic
mode the stove
works at
maximum
capacity all the
time.
1. The thermostat is programmed to the maximum
position.
2. The thermostat for outside air always checks the cool
air.
3. The probe that checks the temperature is defective.
4. The control panel is defective or not working.
1. Set the thermostat temperature again.
2. Change the probe position.
3. Check the probe and change if needed.
4. Check the control panel and change if needed.
The stove does
not turn on
1. Check if there is an electricity interruption.
2. The wooden granules probe is blocked.
3. The pressure switch is not working (says it is
blocked).
4. The smoke vacuum or smoke supply channel is
clogged.
1. Make sure the plug is in and check if the main
switch is in I position.
2. Unblock the probe by checking the thermostat in
the back. If it blocks again change the thermostat.
3. Change the pressure switch.
4. Clean the smoke channel.
Table 8.
INFORMATION ON DISPOSAL (THROWING AWAY) AND
DISMANTLING (PULLING APART) THE STOVE
Dismantling and throwing away, or disposing of an old used stove is the sole responsibility of the owner.
The owner of the stove must abide by the regulations in his/her country related to the safety and environment protection.
Dismantling and disposing of the stove may be left to a third party to do if the third party is a company authorized to collect
and dispose of such materials.
NOTICE: In all cases you must abide by the applicable regulations of the country where the stove is installed regarding
disposal of such materials (things) and, if necessary, report the disposal of such items.
ATTENTION
Dismantling the stove must be done only when the chamber of the stove is not working and when the stove is unplugged
from power (no power supply).
• pull out all electric parts,
• throw away the batteries and electronic cards of the remote control in the proper garbage cans in accordance with the
standards.
• separate the batteries you are keeping from the electric cards,
• dismantle the stove with the help from an authorized company
ATTENTION
Disposing of the stove in public places poses a serious risk for people and animals. In such cases it is always the
responsibility of the owner if a person or an animal gets hurt.
When the stove is dismantled, this manual and all other documents related to the stove must be destroyed.
22.0. THE DURATION OF GUARANTEED SERVICE
By this we mean the time in which we guarantee service, accessories, and spare parts, starting from the date of purchase
of the appliances.
The time of the guaranteed service is in accordance with the legislation.
In case of a change of the model and design of the appliance, the deadline for replacing the parts for which the design has
been changed is within the legal deadline.
After this period the affected parts are provided in the new designs.
22.1. WARRANTY TERMS AND CONDITIONS
Product warranty is valid within the legally defined deadline.
The warranty does not apply to the glass or to the physical damage caused after purchase.
THE MANUFACTURER RESERVES ALL RIGHTS TO CHANGES.
The appliance will, within the warranty period, only function correctly when used in accordance with the instructions for
connection and use.
The warranty ceases to be valid if it is determined that:
- Connecting the product or repair was performed by unauthorized persons, or if they built in counterfeit parts,
- If the appliance is not properly used in accordance with this instructions manual,
