Alfa Romeo Giulia 2019, Руководство пользователя

Страница: 164 / 212

SERVICING AND MAINTENANCE
162
For a correct charge/discharge procedure,
the charge voltage must go through the IBS
sensor.
1. Turn the charger on and follow the
instructions on the user's manual to
completely recharge the battery.
2. When the battery is charged, turn the
charger off before disconnecting it from
the battery.
3. Disconnect the black cable terminal of
the battery charger and then the red
cable terminal.
4. Refit the protective cover of the positive
terminal of the battery and the access
cover to the battery compartment.
NOTE:
If a "quick-type" battery charger is used with
the battery fitted on the vehicle, before
connecting it disconnect both cables of the
battery itself. Do not use a "quick-type"
battery charger to provide the starting
voltage.
DEALER SERVICE
The following pages contain instructions on
the required maintenance from the technical
personnel who designed the vehicle.
In addition to these specific maintenance
instructions specified for routine scheduled
servicing, there are other components which
may require periodic maintenance or
replacement over the vehicle’s life cycle.
Air Conditioning System Maintenance
To ensure the best possible performance, the
air conditioning system must be checked
and undergo maintenance at an authorized
dealer at the beginning of the summer.
Windshield Wiper
Raising The Windshield Wiper Blades ("Service
Position" Function)
The "service position" function allows the
driver to replace the windshield wiper blades
more easily. It is also recommended to acti
-
vate this function when it is snowing and to
make it easier to remove any dirt deposits in
the area where the blades are normally posi
-
tioned, when washing.
Activation Of The Function
To activate this function disable the wind -
shield wiper before setting the ignition
device to STOP.
This function can only be activated within
2 minutes of cycling the ignition to STOP.
To activate this function, move the lever
upwards for at least three seconds.
Windshield Wiper Stalk
Function Deactivation
The function is deactivated if:

More than two minutes passes before
cycling the ignition to the STOP position
after having raised the lever and putting
the wipers into service position.

The ignition is cycled to the ON position,
and the windshield wiper control is used.
If, after using the function, the ignition is set
back to ON with the blades in a position
other than rest position (at the base of the
windshield), they will only return to rest posi
-
tion following a command given using the
stalk (stalk upwards, into unstable position)
or when a speed of 3 mph (5 km/h) is
exceeded.
2019_ALFA_GIULIA_COMBINED_UG_USA.book Page 162