Alfa Romeo Giulia 2019, Руководство пользователя

Страница: 125 / 212

123
The system will return to normal operation as
soon as the accelerator pedal is released.
The system
cannot
be set:

When pressing the brake pedal.

When the brakes are overheated.

When the electric park brake has been
operated.

When either PARK (P), REVERSE (R) or
NEUTRAL (N) is engaged.

When the engine rpm is above a maximum
threshold.

When the vehicle speed is not within the
operational speed range.

When the Electronic Stability Control
(ESC) (or ABS or other stability control
systems) are operating or have just oper
-
ated.

When the ESC system is off.

When the Forward Collision Warning
system is braking automatically.

In the event of system failure.

When the engine is OFF.

In case of obstruction of the radar sensor
(in this case the bumper area where it is
located must be cleaned).
If the system is set, the conditions described
above also cause a cancellation or deactiva
-
tion of the system. These situations may vary
according to the conditions.
NOTE:
The system will not be deactivated when
speeds higher than those set are reached by
pressing the accelerator pedal above
110 mph (180 km/h). In these situations,
the system may not work correctly and it is
recommended to deactivate it.
To Vary The Speed Setting
Increasing Speed
Once the system has been activated, you can
increase the speed by pushing the SET
switch upward. Each time the switch is
pushed, the speed increases by 1 mph.
By pushing and holding the switch upward,
the set speed will increase in increments of
5 mph until the switch is released. Then, the
new speed will be set.
Decreasing Speed
Once the system has been activated, you can
decrease the speed by pushing the SET
switch downward. Each time the switch is
pushed, the speed decreases by 1 mph.
By pushing and holding the switch down -
ward, the set speed will decrease in incre -
ments of 5 mph until the switch is released.
Then, the new speed will be set.
NOTE:

Moving the SET switch allows you to
adjust the speed according to the selected
unit of measurement ("US" or "Metric") set
on the Information and Entertainment
System (see dedicated supplement).

When the unit of measurement is set to
Metric, pushing and holding the SET
switch will adjust the speed in 10 km/h
increments.

By keeping the accelerator pedal
depressed, the vehicle can continue to
accelerate beyond the set speed. In this
case, use the SET switch to set the speed
to the vehicle’s current speed.

When you push the SET button to reduce
the speed, the braking system intervenes
automatically if the engine brake does not
slow the vehicle down sufficiently to reach
the set speed. The device holds the set
speed uphill and downhill; however a
slight variation is entirely normal, particu
-
larly on slight inclines.

The transmission could shift to a lower
gear when driving downhill, or when accel
-
erating. This is normal and necessary to
maintain the set speed

The system will disable while driving if the
brakes overheat.
2019_ALFA_GIULIA_COMBINED_UG_USA.book Page 123