Alfa Laval Toftejorg MultiJet 65, Инструкция по эксплуатации

Страница: 32 / 56

6 Maintenance
MultiJet 65
6.8 Replacement of collar bushes
Replacement of Collar Bushes
1. Place Gear frame (pos. 31) upside down with a firm support under the flange. Use for instance jaws of a vice. Do not clamp
on machined surfaces. With Pusher (tool No. TE81B031, see page 53) knock out Collar bush.
2. Turn Gear frame to upright position and hold over support such as flat steel bar clamped in a vice. Knock out Collar
bush with Pusher.
3. Turn Gear frame 90
0
and hold over support. Knock out collar bush with Pusher.
4. Remove all remains of old Araldite etc. Holes must be perfectly clean before mounting new Collar bushes. Rinse with
chemical cleaner.
5. Coat new Collar bushes with CIBA-GEIGY two component Standard blue Araldite and push into Gear frame.
6. To hold Collar bushes in correct position, insert fixtures (tool No. TE81B032, see page 53) and let harden according to
instructions.
Warning:
To avoid risk of deforming Gear frame, it is utmost important that it is supported while the Collar bushes are
being knocked out.
32