Alfa Laval IsoMix External Drive, Инструкция по эксплуатации

Страница: 6 / 50

2 Safety
Unsafe practices and other important information are emphasised in this manual.
Warnings are emphasised by means of special signs.
Always read the manual before using the machine!
2.4 Safety precautions
INSTALLATION:
Always read the technical data thoroughly (see chapter 7 Technical data).
Always follow installation instructions thoroughly (see chapter 4 Installation).
Never expose the machine to undue vibrations or shocks.
Never start the machine in the wrong rotation direction.
Ensure that the tank media is not corrosive to the machine.
Only install the machine in environments within temperature limit: -5°C and +40°C.
Only install the machine in altitudes lower than 1000 m above sea level. For installation in altitudes higher than 1000 m
above sea level, please contact Alfa Laval.
!
Only use authorized personnel when electrical equipment is connected.
OPERATION:
Always read the technical data thoroughly (see chapter 7 Technical data).
Always read gear motor supplier instructions thoroughly (see chapter 9.3 Drive unit instructions).
Never start the machine in the wrong rotation direction.
Beware of machine in operation can produce sound levels in excess of 85dB(A).
Always rinse well with clean water after cleaning.
Never run the machine motor without liquid recirculation through the machine with a differential pressure of at least 1 bar
!
Always handle lye and acid with great care.
The machine is intended for use inside a tank only. As peak velocity of main jets reaches 40 m/sec., The Alfa Laval
Toftejorg TJ40G must not be operated in open air or when tank is open.
WARNING
Hot chemicals and steam under pressure may be used for cleaning and sterilising. Protect against scalding and
burning. Never tamper with or try to open clamps or other connections while system is in operation. Make sure that
system is depressurised and drained before disassembly.
MAINTENANCE:
Always follow the maintenance instruction thoroughly (see chapter 6 Maintenance).
Always follow the maintenance instruction for gear motor thoroughly (see chapter 9.3 Drive unit instructions).
Always study the parts list and assembly drawing carefully (see chapter 8 Parts lists and drawings, service kits and tools).
Never service the machine or tank with product or cleaning liquid in the tank.
!
Never touch the moving parts while the machine is connected to the power supply.
Always disconnect the power supply while servicing the machine.
Ensure correct rotation direction of drive shaft before startup and after any maintenance that might have impact on
the direction.
TRANSPORTATION:
Always transport the machine in original packaging.
Always support the shaft adequately, to protect shaft and bearings.
Never expose the machine to undue vibrations or shocks.
Control for oil leakage on gears with vent screw.
6