Alfa Laval IsoMix External Drive, Инструкция по эксплуатации

Страница: 10 / 50

4 Installation
All position numbers and item numbers refer to the drawings shown and specified in chapter 8.1 IMXD without middle
section and 8.2 IMXD with middle section.
4.4 Requirement for installation, personnel
Installers:
-
Experience from similar types of installation.
- Proven skills in reading installation guidelines and drawings ensuring that the installation is carried out safely for personnel
and property.
Electrician:
-
Certified according to local regulations and experience from similar types of installation.
- Proven skills in reading installation guidelines and drawings ensuring that the installation is carried out safely for personnel
and property.
4.5 Installation, mechanically
Requirements for installation
This work should be carried out by at least two persons.
During installation ensure to use sufficient lighting.
Ensure that the tank does not contain liquid or gas.
Always have safety elements removed by authorized personnel.
Never cover or remove nameplates.
Always use lifting equipment when handling heavy parts of the machine.
Never connect to power during installation.
Always have the machine connected to power supply by authorized personnel.
For more information on the gear motor go to chapter 9.3 Drive unit instructions and Frequency converter chapter 9.4
Frequency converter instructions.
NOTE
The frequency converter attached to the gear motor is pre-programmed with a start ramp up time of 8 sec and maximum 60%
of the motors nominal value. Also it is set to only be able to run between 10 and 50Hz.
In case the user choose to use alternative frequency converter it has to be setup with parameters identical to the above.
During electrical installation:
1. Electronically connect motor by authorized personnel
2. Check direction of rotation
A. Ensure the rotation direction is counter-clockwise, when viewed from the bottom of the motor. Momentarily start and
stop the motor (max 1 sec) to verify direction of rotation.
3. For more information on the electrical installation see section 4.6 Installation, electrically.
Tools for installation
- 2x strap wrench f. OD Ø85
- 10 mm socket w. rachet (or 10 mm fork key spanner)
- 2x 17 mm fork key
- 13 mm socket w. rachet (or 13 mm fork key spanner)
- Flat headed screw driver
10