Alfa Laval FrontLine ClipLine, Инструкция по эксплуатации, Страница: 8 / 68

Maintenance and installation of the plate heat exchanger shall be done by
persons who have knowledge and authorization according to local regulations.
This may include actions such as piping, welding and other kind of
maintenance.
For maintenance actions not described in this manual, contact your Alfa Laval
representative for advice.
1.4 Delivered technical information
For the manual to be considered complete, the following delivered
documentation must be accessible to the users of this instructions manual:
• Declaration of Conformity
• Spare parts list
A bill of material as the equipment is built.
• Plate hanging list
A description of the channel plate installation.
• Technical specification
Connection information, measurements, and section information.
• Plate heat exchanger (PHE) drawing
A drawing of the delivered plate heat exchanger.
The weight of the delivered plate heat exchanger as well as all dimensions
can be found on the delivered PHE drawing.
The listed documents are unique for the delivered product (equipment serial
number). Instructions shall be accompanied, where appropriate, by the
technical documents, drawings and diagrams necessary for a full
understanding of these instructions.
The PHE drawing mentioned in this manual are the drawings included in the
delivery.
1.5 Warranty conditions
The warranty conditions are usually included in the signed sales contract prior
to the order of the delivered plate heat exchanger. Alternatively, the warranty
conditions are included in the sales offer documentation or with a reference to
the document specifying the valid conditions. If faults occur during the
specified warranty period, always consult your local Alfa Laval representative
for advice.
Report to the local Alfa Laval representative, the date when the plate heat
exchanger was put into operation .
1.6 Advice
Always consult your local Alfa Laval representative for advice on:
• New plate pack dimensions if you intend to change the number of plates
• Selection of gasket material if operating temperatures and pressures are
permanently changed, or if another medium is to be processed in the plate
heat exchanger
200000420-4-EN-GB 8
1 Introduction EN