Alfa Laval FrontLine ClipLine, Инструкция по эксплуатации, Страница: 35 / 68

4.5 Lifting the equipment
It is recommended to engage the services of a rigging company to take care of
all handling related matters until the equipment is in the position where it will
be installed.
WARNING Risk of personal injury.
Equipment is heavy with a centre of gravity placed high.
Lifting and transport of the crated and uncrated equipment must be carried
out by skilled persons. See Section
Prior knowledge in Chapter
Introduction .
WARNING Risk of personal injury.
The equipment or loose objects can fall. Plastic straps may snap when cut
off. There can be sharp edges, splinters, and nails on the crate and the
equipment.
Wear personal protective equipment when handling the equipment during
unpacking and installation. Handle the equipment with precaution. See
Section
Personal protective equipment in Chapter Safety .
WARNING Risk of personal injury.
Never work under hanging load.
WARNING Risk of personal injury.
Never work alone during lifting and handling of the crated or uncrated
equipment.
The authorized personnel are always responsible for the safety, correct
selection of lifting equipment and execution of the lifting and raising
procedures. Use undamaged hoist slings approved for the weight of the plate
heat exchanger. Use the lifting points as illustrated. If the equipment has lifting
eye bolts, these must be used.
If otherwise not stated, use two hoist slings (1) and (2) and make sure that the
lifting angle (α) is between 45° and 90°.
α
α
α
α
1 2
Figure 5: The illustration shows the threading of the hoist slings.
200000420-4-EN-GB 35
Installation 4 EN