Alfa Laval Alfie, Инструкция по эксплуатации

Страница: 45 / 80

9 Maintenance
Check the condition of discs in the bowl, replace if necessary.
Fit new vibration dampers.
To get access to the dampers, only remove the
three screws and washers shown in illustration
10 on page
52 . Inspect the stop flanges of the
dampers for possible damage and replace the
stop flanges with new ones if necessary. Use
Loctite 243 at assembly, see illustration 33 in
chapter 9.4.5 Replacement of motor bearings.
9.4 Every second year
9.4.1 Separator
Check/replace the disc stack to maintain the separation efficiency.
See 9.5.3 Replacement of O-rings on page 50 for procedure.
9.5 Dismantling - assembly instructions for separator
9.5.1 Introduction
The illustrations on the following pages describe step by step how to dismantle, clean, replace and
assemble the various parts of the separator.
The illustrations have symbols only to indicate the actions required. The key to the symbols
is given below.
Remove
Screw
or turn
clock-
wise
Press
or move
in the
direction
of arrow
Clean
Fit, insert
Screw
or turn
counter-
clock-
wise Check,
make sure Safety
45