05-27-09
®
ALERTE SYSTEMS INC
901 W 10th Street / P.O. Box 586 / Cassville, MO 65625
Local & International Numbers: U.S. and Canada Toll-Free Numbers:
Phone 417-846-2222 / Fax 417-846-2506 Phone 800-728-1536 / Fax 800-635-1536
ALERTE
ALERTE
ALERTE
MODEL NO. 10.730
Visor Light 88
GENERAL INFORMATION:
INSTALLATION INSTRUCTIONS:
Two super bright LED arrays, 44 LED's per side. There are other array combinations to suit your jurisdiction or
ordinance requirements from RED, BLUE, AMBER, GREEN or WHITE LED's. Each array equipped with vertical
rows of white LEDs at their outer edges to provide the "halo" effect pioneered by ALERTE to enhance visibility.
Seven flash patterns to choose from:
1. 90 Single FPM Simultaneous
2. 90 Double FPM Simultaneous
3. 70 Quad FPM Simultaneous
4. 120 Alternating FPM
5. Automatic Alternating Variable Speed
6. Automatic Simultaneous Variable Speed
7. Automatic Random Select
To change flash pattern, press the momentary switch (Located on the lighter plug adapter). Each time the
momentary switch is pressed, the flash pattern will change.
Position the "Visor Light" on the visor, normally on the passenger side with the lenses facing downward when the
visor is in the up position.
Fasten the straps over the visor and position the "Visor Light" with its bottom edge even with the lower edge of the
visor. Tighten the straps to snug the "Visor Light" against the visor.
Clean the cable clip location on the windshield column and the dash with 409
®
, Fantastic
®
, or the equivalent prior to
affixing the clips. This procedure is particularly important if a silicone-based protectant such as Armor All
®
has been
used on these surfaces. Failure to adequately clean the clip mounting locations may prevent the adhesive on the
clips from securing a sound, long-lasting grip.
Place the cable in the clips. Open the clips only as much as necessary to insert the cable.
To operate, flip the visor down, insert the cable plug into the cigarette lighter socket and switch on.
NOTE:
If the "Visor Light" is to be permanently wired, please specify at the time of the order, so when manufacturing
your light we can adjust the location of the switch. The current switch is located on the cigarette adapter.
