Visit our website at
www.alemlube.com.au
or
www.alemlube.co.nz
NSW/ACT
TEL: (02) 9677 1555
FAX: (02) 9675 1155
QLD/PNG
TEL: (07) 3204 9166
FAX: (07) 3204 1224
VIC/TAS
TEL: (03) 8787 8288
FAX: (03) 8787 8266
WA
TEL: (08) 9302 4199
FAX: (08) 9303 2095
SA/NT
TEL: (08) 8241 7111
FAX: (08) 8241 7011
NZ
TEL: (09) 447 1007
FAX: (09) 447 1008
2
Mobile Waste Oil Drainer / Extractor
OWNER’S TECHNICAL MANUAL
30100
GENERAL SAFETY REGULATIONS
WARNING:
When using tool, basic safety precautions should always be followed to reduce the risk
of personal injury and damage to equipment.
1.
Keep work area clean. Cluttered areas invite injuries.
2.
Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose
to rain. Keep work area well lighted. Do not use electrically powered tools in the presence of flammable gases
or liquids.
3.
Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools
or extension cords.
4.
Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust.
Always lock up tools and keep out of reach of children.
5.
Avoid Unintentional Starting. Be sure the air pressure is in the off position when not in use and before making
hose connection.
6.
Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.
7.
Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked
to determine that it would operate properly and perform its intended function. Check for alignment
and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect
proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician.
Do not use the tool if any control or switch does not operate properly.
8.
Replacement parts and accessories. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty. Only use accessories intended for use with this tool.
9.
Do not operate tool if under the influence of alcohol or drugs. Read warning labels if taking prescription
medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt,
do not operate the tool.
10.
Maintenance. For your safety, service and maintenance should be performed regularly by a qualified technician.
Note: Performance of this tool may vary depending on variations in air pressure and compressor capacity.
SPECIFIC SAFETY RULES
This equipment is designed be operated by qualified personnel. It should only be operated after reading
and understanding the safety warnings and operating procedures in this instruction manual.
1.
Do not smoke near this equipment.
2.
Use in a well ventilated area.
3.
When leaks are found in the equipment or hoses, immediately turn the air pressure off and repair the leaks.
4.
Do not exceed the recommended operating air pressure. This could damage equipment.
5.
Keep a type ABC fire extinguisher nearby in case of fires.
6.
Always protect your skin and eyes from contact with oil and solvents.
7.
Do not start engine during the time of oil extraction. Otherwise it will cause the damage of extraction probes
and injuries of people.
8.
Be careful for the oil extracted out from the vehicle, as temperature of oil is high, always between 40~60
°
C.
9.
Used oil should be properly disposed or recycled. Please contact with your local waste liquid/solid authority
for information on recycling.
10.
Can be used with other mechanical engine oil, lubricants as well as temporary storage. Brake fluid, gasoline,
diesel and other liquid contains methanol and ketones or flammable is strictly prohibited.
